Oki 58374501 Manual do Utilizador Página 1

Consulte online ou descarregue Manual do Utilizador para Impressoras Oki 58374501. Oki 58374501 User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 8
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
Finisher Unit Installation Guide
Components
1
Finisher Unit
7
Inverter Stand
2
Finisher stand
8
Clear Band
3
Finisher Stacker
9
Band Stopper, Small
4
Finisher Cover
10
Band Stopper, Large
5
Power Cord
11
Metal Brackets
6
Inverter Unit
12
Cable (inverter to printer)
Not illustrated: Screws
Step 1: Prepare the Printer
1. Turn the printer off (
!
) and disconnect the
power cord (
"
) and interface cable (
#
).
2. Using a screwdriver, remove the breakout
panels on the side of the printer.
Vista de página 0
1 2 3 4 5 6 7 8

Resumo do Conteúdo

Página 1 - Step 1: Prepare the Printer

Finisher Unit Installation GuideComponents1Finisher Unit7Inverter Stand2Finisher stand8Clear Band3Finisher Stacker9Band Stopper, Small4Finisher Cover1

Página 2 - Step 2: Prepare the Inverter

23. Install the metal brackets where the breakout panels were.4. Open the face-up stacker (!), then open the flap and press it onto the stacker surfac

Página 3

32. Remove the two bottom caps:a. Turn the inverter over. b. Remove the two screws securing the bottom caps on either side of the inverter.c. Remove t

Página 4 - Step 3: Assemble the Inverter

45. Pull forward on the extension plate to disengage the pins from the top channel stops, then slide it down into the inverter and push back to engage

Página 5 - Step 4: Assemble the Finisher

52. Attach the front of the inverter to the stand using two screws on either side.3. Attach the back of the inverter to the stand using one screw on e

Página 6

63. Place the finisher cover near the back of the finisher. Locate the tab (!) on the right side of the cover.4. Hold the clear band perpendicular to

Página 7

78. Pull the finisher platform about half way out, then loosen the screw on the locking piece (!: viewed from the opposite direction) so that it drops

Página 8 - Step 5: Make Connections

12. Secure the stacker with four screws.13. Push the finisher against the printer until the prongs on the printer brackets fit into the holes in the f

Comentários a estes Manuais

Sem comentários