OKI ML521 Manual do Utilizador descarregar pdf (Página 195)

Page: 134

Service Guide ML520/521

Chapter 4 Failure & Repair Analysis

RAP 03 Printhead Homing Error

START

Printhead does not return to the home position.

Make sure the carriage cable is properly connected to the space motor assembly and CN8 on the main

control board.

Make sure the power connector cable is properly connected to CN3 on the main control board.

Does the space motor assembly move manually?

No Remove the space motor assembly and inspect the space motor and space rack for dirt and worn

teeth.

Go to A

Yes Are there any breaks in the carriage cable?

Yes Replace the carriage cable assembly.

Go to A

No Verify that ribbon feed mechanism is properly fastened to the space motor assembly.

Go to A

Does the carriage move slightly to the left after turning the power on?

No Replace the space motor assembly.

Has the problem been resolved?

Yes End of procedure.

No Contact Technical Support.

Yes Replace the ribbon feed assembly.

Has the problem been resolved?

Yes End of procedure.

No Replace the main control board.

Has the problem been resolved?

Yes End of procedure.

No Replace the space motor assembly.

Has the problem been resolved?

Yes End of procedure.

No Contact Technical Support.

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 268 269

OKI ML521 Manual do Utilizador Página 195