OKI 00036103 Ficha Técnica Página 1

Chapter 1Unpacking Check The Contents

Note: If the sheet of paper doesn't feed in properly, the 15 light on the front panel flashes. To correct this, press the SHIFT and RESET buttons

Setting the Top of Form for Single-Sheet Paper

Temporarily Changing the Top of Form Setting for Single-Sheet Paper

Rear-Feed Paper

Preliminaries

Loading Rear-Feed Paper

Close the paper separator and swing the wire feed guide forward so that it rests on the pull-up roller assembly (7).Note:The wire feed guide keeps the

Temporarily Changing the Top of Form Setting for Rear-Feed Paper

Paper Handling Features Tear Feature

Form Tear-Off Feature

Remove the Protective Film

To set the Top of Form with the FormTear-Off feature engaged, push and hold the SHIFT and TEAR buttons (3) to see the current Top of Form setting. The

Paper Park Feature

Switching from Continous-Form Paper to Single-Sheet Paper

Switching from Single-Sheet Paper to Continuous-Form Paper

Chapter 3The Font Test (Self Test)

The Rolling ASCII Test

Chapter 4Emulations

Changing Emulations

Selecting a Printer Driver

Chapter 5Front Panel Overview

Remove the Shipping Retainers

Print Mode

Menu Mode

Entering the Menu Mode

The Printer Menu

Active Buttons in Menu Mode

Chapter 6Problem Solving

(Character Pitch) button. The ALARM light will come on and you will be able to load the paper.Problem: My word processor files don't print the wa

Clearing Rear-Feed Paper Jams

Solving the Problem of Continuing Rear-Feed Jamming

Turn the platen knob to bring the quadruple-thick paper up around the platen. This will bring jammed pieces of paper up and out.Back the quadruple-thi

Install the Ribbon Cartridge

ML590/

Clearing Single-Sheet Feed Jams

Cleaning the Housing

Appendix AMenu TableMenu TableThe table below lists the Menu entries for your printer. The factory defaults are shown in bold italic. Note: The table

Gap ControlAuto Gap, Semi Auto Gap, 1, 2, 3, 4, 5, 6, 7, 8, 9Bottom Feed Line Spacing6 LPI, 8 LPIForm Tear-OffOff, 500ms, 1 sec, 2 secSkip Over Perfor

SI Select Pitch, 10 cpi (appears only when IBM Proprinter emulation is selected)17.1 CPI, 15 CPISI Select Pitch, 12 cpi (appears only when IBM Proprin

Page Length11, 11-2/3, 12, 14, 17, 3, 3.5, 4, 5.5, 6, 7, 8, 8.5Gap ControlAuto Gap, Semi Auto Gap, 1, 2, 3, 4, 5, 6, 7, 8, 9CSF Bin 2 (appears only wh

Appendix pendixSpecificationsSpecificationsPrint Method: Impact dot matrixPrinthead: 24 pins, 0.20 mm diameter, automatically adjusting to paperthickn

cyan = 1.5 million characters magenta = 1.5 million characters yellow = 0.8 million charactersPaper SpecificationsWidth, Minimum: 3" Width, Maxim

Connect to Your Computer and to the Power Line

Turn on the Printer

Chapter 1Single-Sheet Paper

Preliminaries

Loading Single-Sheet Paper